Ocean-electronic Tabletop Heater Manuel d'utilisateur télécharger pdf (Page 10)

OWNER’S MANUAL

Make 1-2 oz. of leak solution by mixing one part liquid dishwashing soap

and 3parts water.

Spoon several drops(or use squirt bottle ) of the solution onto the

regulator/canister connections.

Inspect the connections and look for bubbles.

If NO bubbles appear, the connection is safe.

If bubbles appear, there is a leak:

Loosen and re-tighten this connection.

Re-check for a leak.

If you continue to see bubbles after several attempts, disconnect propane

source.

● The tabletop heater is primarily for outdoor

use only. Always ensure that adequate fresh

air ventilation is provided.

● Always maintain proper clearance to

combustible materials, i.e. top 45 cm(18”)

and sides 60 cm(24”) minimum.

● Tabletop heater must be located on a

stable and strong table.

● Never operate heater in an explosive

atmosphere like in areas where gasoline or

other flammable liquids or vapors are stored.

TABLETOP HEATER LOCATION

CHECKING FOR LEAKS

I am familiar with entire owner's manual and understand all

precautions noted in “Safety First”.

All components are properly assembled, intact and operable.

No alterations have been made.

All gas connections are secure and do not leak.

Wind velocity is below 10 mph.

Outdoor temperature is greater than 40 degrees F.

Heater is outdoors (outside any enclosure).

There is adequate fresh air ventilation.

Heater is away from gasoline or other flammable liquids or vapors.

Heater is away from windows, air intake openings, sprinklers and

other water sources.

Heater is at least 18 clearance (top) and 24” clearance (side) from

combustible materials.

“

BEFORE OPERATING

1 2 ... 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Ocean-electronic Tabletop Heater Manuel d'utilisateur Page 10